Pumps

  $15 /day  * $45 /wk * $135 /month 

Air sampling low flow modules for GilAir-3 and GilAir-5, enabling low flow sampling with these personal air sampling pumps.

Multi flow allows 0.001 - 0.75L/ min

Constant flow allows 0.005 - 0.5 L/min

We carry 3 multi flow units and 1 constant flow unit.

$35 /day  * $100 /wk * $250 /month 

This IAQ Pump operates at a flow rate of  3 to 30 LPM. This lightweight pump (only 4.5 lbs.) is ideal for any IAQ air sampling project. Suited for Air-O-Cell it is not recommended for use with any type of filter cassettes due to the high back pressure levels.  

We carry 1 unit. 

 $15 /day  * $45 /wk * $135 /month  

Fast measurement with one hand: The Dräger-Tube pump accuro allows you to use the established Dräger-Tubes to take measurements under extreme conditions. The easy-to-use Dräger-Tubes have already been calibrated and form a perfect unit with the Dräger-Tube pump.
We carry 1 unit.

This OVS Adapter Kit can be used to combine sorbent, and trap aerosols and vapors into one glass. The kit comes with two sections of tubing as well as a calibration adapter that can used to calibrate a small pump using an OVS sorbent tube.

We carry 2 kits.

This Dual Port High/Low Flow Manifold consists of a dual needle valve that can utilize constant flow for single samples or multi-flow for simultaneous sampling. This equipment requires sampling media systems that use particular filter cassettes and/or sorbent tubes to capture particulates, gases, and vapors.

We carry 1 unit.  

This Universal Tube Holder System allows constant low flow and constant pressure (multi-flow) operation. It can be used to absorb gases and vapors using sorbent tubes. The holder eliminates contamination within the tubes, prevents breakage, and allows “in-line” calibration.

We carry 2 units. 

 $10 /day  * $30 /wk * $90 /month

This cyclone provides sharp size selection between inhalable and respirable fractions at 4um. The SKC Aluminum Cyclone is constructed of conductive aluminum to eliminate the electrostatic problems associated with nylon cyclones and allows more efficient particle sampling.
We are carrying 6 sets of aluminum cyclone and their filter holders and 1 calibration chamber.

 $10 /day  * $30 /wk * $90 /month  

The Zefon Conductive Nylon Cyclone is to be used for collecting air samples in environments where large particulates might otherwise clog a cassette filter. The cyclone is designed to separate respirable dust particles so they can be collected onto a filter and analyzed. Larger particles fall into a grit pot and are discarded.
We are carrying 6 sets of Nylon cyclones and their filter holders and 1 calibration chamber.

  $10 /day  * $30 /wk * $90 /month

Zefon Field Rotameters are a low cost way to measure airflow in air sampling applications. Operation and maintenance are very simple; only a few common sense precautions must be observed to assure long, trouble-free service. We carry 3 rotameters with flow rate of 1-4 LPM and 1 with flow rate of 2-20 LPM.

We can also check the calibration of your rotameters using our primary calibrator for $25 / unit.

$5 / tubing 

Air-o-cell inner wall sampling tubing, we will lend you the adapter.

$20 / bag

Zefon 5 Liter Tedlar® Bag with ZP Valve 

 $35 / unit

Oakton PC 450 Waterproof Portable meter with combination pH/conductivity/temperature/salinity/TDS/ATC probes. Comes calibrated in hard carrying case.